bombnecklace

Bomb Necklace

11 discs drilled at an angle, with 1cm tubing as spacers, with black oxidised silhouette of bomb motif positioned on the left hand side.

Silver & 16" silver snake chain

bomb earrings

Boom Studs, 2011

Silver bomb silhouettes that stand vertically on the earlobe.

NA

bomblace_2

Bomb and Chain, 2011

This piece has been donated to the FiorGen Onlus Foundation in co operation with Preziosa Young 2011. The auction will be conducted October 22, 2011 in the “Hall of Skeletons” of the "La Specola”, Museum of Natural History, Florence.

NA

bomblace

Bomblace

Boom Brooch

Boom Brooch

Brooch body made from a silver hemisphere.
Handmade festening for steel pin.

70 x 35mm

Boom Brooch
Wired Brooch

Wired Brooch

Large silver brooch constructed using 2mm square wire.

80 x 87 x 2mm

Boom

Boom

Two silver hemispheres were soldered together to make a whole, using a doming block. The top part of the bomb is constructed from a soldered ring conntected onto a flat sheet. Inner rim was filed at an angle and soldered onto the sphere. A hole was pierced in the lower part of the sphere to make the ring shank.

50 x 50mm

Boom
Bomblace

Bomblace

Nine silver bombs constructed in the same manner as Boom ring. The bombs are strung on steel cable and held in place using silver crimps and then covered in rubber tubing.

Bombs: 60 x 60mm ranging 14 x 14mm
100cm long cable and rubber tubing

Wired

Wired

Silver wire bomb ring constructed using 1.5mm square and 0.2mm wire to form the fuse. Using the Meander Ring technique, the 0.2mm wire is wrapped around two nails repeatedly in a figure of eight shape to make part of the setting. Shank is U shaped and soldered to the piece last.

20 x 23mm

Wired
Black Fuse Ring

Black Fuse Ring

Wire illustration of bomb, soldered onto a 1mm back plate and then oxidised. Fuse made from twisted wire with soldered.

25 x 28 x 22mm

Black Fuse Ring

© Sam Hamilton 2011